The Jeti Box, sometimes referred to as the Jeti Spin Box is a simple two-way LCD terminal with a two-line display, for interfacing with a number of Jeti products.
The Jeti Box can be used for all sorts of tasks:
- Communication with Jeti Spin controllers, REX Receivers, Sensor 3000 and future Jeti products.
- Measurement of pulse widths at the receiver output (shows the pulse width in milliseconds and the receiver supply voltage).
- Acts as a pulse-generator, generating control pulses which can be adjusted by means of push buttons and shows the servo supply-voltage.
This function is very well suited for servo adjustments directly in the plane without the necessity of receiver installation and the use of a transmitter.
- Servo cycling: Servos can be cycled by connecting a power source to the Jeti Box along with the servo.
Various parameter can be adjusted: number of cycles, servo throw, cycling speed.
This feature can be used to verify servo lifetime (i.e. burn-in) and their function.
- Measurement of servo speed (The time which the servo needs to travel from one defined position to another position.
Limiting points may be defined for a 60° servo-arm throw.
Measurements can be executed with no load or with a servo installed in the plane.
- Programming of Jeti Duplex receivers.
- Viewing of real time data such as receiver voltage and signal strength from all Jeti Duplex receivers when connected to a Duplex transmitter module.
- Viewing of real time data such as rate of climb/descent, temperature, voltage, current and battery capacity from Jeti Duplex telemetric sensors.
- Can also be used as a stand-alone Watt Meter or Temperature Sensor
when used with the corresponding Jeti Duplex telemetric sensor and an appropriate power source such as a receiver battery or a 2-cell LiPo or LiFePO4 pack.
|
